Button and LED#
On the back side of the movement a button and an LED allow for basic interaction.
Button#
The following functions can be released through the operation key (see picture):
If the key remains pressed between 1 and 5 seconds, GNSS synchronization is turned on. The LED flashes during this time.
If the key remains pressed for more than > 5 seconds, the clock runs to the 12 o’clock position and will remain there for 10 minutes. During this time it is possible to charge a time offset on the movement as per the user’s requirements. After the end of the 10 minutes or after that the key has been briefly pressed, the clock runs to the correct time again (under condition that the clock is synchronized).
Should the clock has to be dismantled or the hands adjusted again, it is recommended to remove the power supply, after that the hands have stopped on 12 o’clock. It will thus be avoided, that the hands suddenly will start running again after 10 minutes.
LED#
On the side of the movement, near the connectors an LED shows the status of the Movement. If GNSS reception is on, this LED flashes once a second. If the battery is empty, it flashes fast 10 times every time the clock hand move (every full minute).